板状燃料组件流量分配CFD研究与优化

董化平; 樊文远; 郭赟

doi:10.11889/j.0253-3219.2016.hjs.39.080603

您当前的位置：

首页 >

文章列表页 >

板状燃料组件流量分配CFD研究与优化

核能科学与工程 | 更新时间：2021-05-24

- 板状燃料组件流量分配CFD研究与优化
- CFD investigation and optimization on flow distribution of plate-type assembly
- 核技术 2016年39卷第8期文章编号：080603
- 作者机构：
  
  1.中国核动力研究设计院核反应堆系统设计重点实验室成都 610041
  2.中国科学技术大学核科学技术学院合肥 230026
- 作者简介：
  
  [ "董化平, 男, 1979年出生, 2005年于西安交通大学获工学硕士学位, 现主要从事核电站设计与安全分析工作", "DONG Huaping, male, born in 1979, graduated from Xi'an Jiaotong University with a master's degree of engineering in 2005, engaged in nuclear power plant design and safety analysis" ]
  郭赟, E-mail:guoyun79@ustc.edu.cn GUO Yun, E-mail: guoyun79@ustc.edu.cn
- 基金信息：
  
  中国核动力研究设计院核反应堆系统设计技术重点实验室开放基金项目(No.HT-CENT-02-2014001);国家核聚变专项(No.2013GB108004)
- DOI：10.11889/j.0253-3219.2016.hjs.39.080603
  中图分类号： TL331
- 收稿日期：2016-04-30，
  
  修回日期：2016-06-30，
  
  纸质出版日期：2016-08
- 稿件说明：
移动端阅览
董化平, 樊文远, 郭赟. 板状燃料组件流量分配CFD研究与优化[J]. 核技术, 2016,39(8):080603

Huaping DONG, Wenyuan FAN, Yun GUO. CFD investigation and optimization on flow distribution of plate-type assembly[J]. Nuclear techniques, 2016, 39(8): 080603
董化平, 樊文远, 郭赟. 板状燃料组件流量分配CFD研究与优化[J]. 核技术, 2016,39(8):080603 DOI： 10.11889/j.0253-3219.2016.hjs.39.080603.

Huaping DONG, Wenyuan FAN, Yun GUO. CFD investigation and optimization on flow distribution of plate-type assembly[J]. Nuclear techniques, 2016, 39(8): 080603 DOI： 10.11889/j.0253-3219.2016.hjs.39.080603.

摘要

板状燃料组件被广泛应用于研究堆中，组件内的流量分配是设计时需要考虑的一项重要内容。计算流体动力学（Computational Fluid Dynamic

CFD）方法是研究流量分配的重要手段，但有限的计算资源限制了其在板状燃料组件流量分配研究中的推广。针对板状燃料组件冷却剂流道狭长、封闭的特点，提出了部分建模迭代求解的计算方式，将无流量分配组件与有流量分配组件两种工况下各流道流量的计算值与直接完整建模的结果进行了对比，最大误差分别为0.56%与0.81%。鉴于前者对计算资源的需求远小于后者，部分建模迭代求解可以作为板状燃料组件流量分配CFD研究的合理可信的优化方案。

Abstract

Background:

Plate-type assembly is widely used in research reactors. Flow distribution inside the assembly is a key factor in design process. Computational fluid dynamics (CFD) method is an important way for flow distribution calculations. However

huge requirements on computing resources limit the application scope of CFD method.

Purpose:

The aim is to invest the CFD method in the flow distribution with smaller requirements on computing resources.

Methods:

New developed CFD method by partial modeling and iterating is used.

Results:

Using the traditional CFD and newly developed method

flow distribution calculations are done toward plate-type assembly with and without the flow distributor

and the maximum differences are 0.81% and 0.56%

respectively.

Conclusion:

The partial modeling and iterating method could optimize CFD simulations on flow distribution of plate-type assembly accurately

economically and quickly.

关键词

Keywords

references

李健全 , 陈晓明 , 李金才 . 板状燃料堆芯流道阻塞事故分析 . 原子能科学技术 , 2002 . 36 ( 1 ): 76 - 79 . http://www.cnki.com.cn/Article/CJFDTOTAL-YZJS200201017.htm .

Jianquan LI , Xiaoming CHEN , Jincai LI . Analysis on a flow blockage incident at a plate-type fuel reactor . Atomic Energy Science and Technology , 2002 . 36 ( 1 ): 76 - 79 . http://www.cnki.com.cn/Article/CJFDTOTAL-YZJS200201017.htm .

宋磊.板状燃料组件堵流事故数值分析[D].哈尔滨:哈尔滨工程大学, 2013 http://cdmd.cnki.com.cn/article/cdmd-10217-1014132135.htm

SONG Lei. Numerical analysis of the flow of the plate fuel assembly[D]. Harbin:Harbin Engineering University, 2013

宋磊 , 郭赟 , 曾和义 . 板状燃料组件入口堵流事故下流场和温度场的瞬态数值计算 . 核动力工程 , 2014 . 35 ( 3 ): 6 - 10 . http://www.cnki.com.cn/Article/CJFDTOTAL-HDLG201403002.htm .

Lei SONG , Yun GUO , Heyi ZENG . Numerical analysis on transient flow and temperature field during inlet flow blockage accidents of plate-type fuel assembly . Nuclear Power Engineering , 2014 . 35 ( 3 ): 6 - 10 . http://www.cnki.com.cn/Article/CJFDTOTAL-HDLG201403002.htm .

W Fan , C Peng , Y Guo . CFD study on inlet flow blockage accidents in rectangular fuel assembly . Nuclear Engineering and Design , 2015 . 292 177 - 186 . DOI: 10.1016/j.nucengdes.2015.06.016 http://doi.org/10.1016/j.nucengdes.2015.06.016 .

Q Lu , S Qiu , H G Su . Development of a thermal-hydraulic analysis code for research reactors with plate fuels . Annals of Nuclear Energy , 2009 . 36 ( 4 ): 433 - 447 . DOI: 10.1016/j.anucene.2008.11.038 http://doi.org/10.1016/j.anucene.2008.11.038 .

Q Lu , S Qiu , G H Su . Flow blockage analysis of a channel in a typical material test reactor core . Nuclear Engineering and Design , 2009 . 239 ( 1 ): 45 - 50 . DOI: 10.1016/j.nucengdes.2008.06.016 http://doi.org/10.1016/j.nucengdes.2008.06.016 .

陈道龙 , 姜琲 . 高通量工程试验堆堆芯燃料元件温度-流量测量装置 . 核科学与工程 , 1984 . 4 ( 6 ): 178 - 181 . http://www.cnki.com.cn/Article/CJFDTOTAL-HKXY200004005.htm .

Daolong CHEN , Bei JIANG . The in-core fuel element temperature-flow measurement facility of HFETR . Chinese Journal of Nuclear Science and Engineering , 1984 . 4 ( 6 ): 178 - 181 . http://www.cnki.com.cn/Article/CJFDTOTAL-HKXY200004005.htm .

陈道龙 , 姜琲 . 高通量工程试验堆堆芯燃料元件温度和流量测量 . 中国核科技报告 , 1988 . ( S2 ): 1 - 28 . http://www.cnki.com.cn/Article/CJFDTOTAL-ZHBG198700060.htm .

Daolong CHEN , Bei JIANG . The in-core fuel element temperature and flow measurement facility of HFETR . China Nuclear Science and Technology Report , 1988 . ( S2 ): 1 - 28 . http://www.cnki.com.cn/Article/CJFDTOTAL-ZHBG198700060.htm .

Fan W, Peng C, Wang G, et al. CFD study on inlet flow blockage accidents in multi-layer annular flow channels[C]. ICONE23(Paper ID:1845), Japan, 2015

樊文远 , 郭赟 , 彭常宏 . 多层环形流道阻塞事故三维数值分析初步探索 . 核动力工程 , 2016 . 37 ( 1 ): 123 - 128 . http://www.cnki.com.cn/Article/CJFDTOTAL-HDLG201601030.htm .

Wenyuan FAN , Yun GUO , Changhong PENG . Preliminary 3D numerical study on flow blockage accident in multi-layer annular flow channels . Nuclear Power Engineering , 2016 . 37 ( 1 ): 123 - 128 . http://www.cnki.com.cn/Article/CJFDTOTAL-HDLG201601030.htm .

W Fan , C Peng , Y Chen , . A new CFD modeling method for flow blockage accident investigations . Nuclear Engineering and Design , 2016 . 303 31 - 41 . DOI: 10.1016/j.nucengdes.2016.04.006 http://doi.org/10.1016/j.nucengdes.2016.04.006 .

汪利民 , 宗桂芳 , 尹涛 . 600MW反应堆堆芯入口流量分配实验研究 . 工程热物理学报 , 1999 . 20 ( 2 ): 185 - 189 . http://www.cnki.com.cn/Article/CJFDTOTAL-GCRB199902011.htm .

Limin WANG , Guifang ZONG , Tao YIN . Test of flow distribution at the core in let of 600 MW reactor . Journal of Engineering Thermophysics , 1999 . 20 ( 2 ): 185 - 189 . http://www.cnki.com.cn/Article/CJFDTOTAL-GCRB199902011.htm .

ANASYS. ANASYS FLUENT 12.0 theory guide[Z]. Canonsburg, PA, USA, 2009

浏览量

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

双面冷却熔盐堆组件热工分析程序开发与验证

10 MW级液态燃料熔盐堆堆芯流量分配优化设计研究

2 MW液态钍基熔盐实验堆气载放射性流出物近场扩散的数值模拟

一种液态燃料熔盐堆堆芯流量分配设计