数字射线扫描成像系统MTF的测试分析

孙朝明; 汤光平; 王增勇; 李强

doi:10.11889/j.0253-3219.2016.hjs.39.070203

您当前的位置：

首页 >

文章列表页 >

数字射线扫描成像系统MTF的测试分析

低能加速器技术、射线技术及应用 | 更新时间：2021-05-24

- 数字射线扫描成像系统MTF的测试分析
- Analysis of MTF in digital radiography using linear detector array
- 核技术 2016年39卷第7期文章编号：070203
- 作者机构：
  
  中国工程物理研究院机械制造工艺研究所绵阳 621900
- 作者简介：
  
  [ "孙朝明,男,1977年出生,2002年于上海大学获硕士学位,高级工程师,研究领域为无损检测技术应用", "SUN Chaoming, male, born in 1977, graduated from Shanghai University with a master’s degree in 2002, senior engineer, focusing on application of nondestructive testing technology" ]
- 基金信息：
  
  中国工程物理研究院技术基础科研项目(14S105)
- DOI：10.11889/j.0253-3219.2016.hjs.39.070203
  中图分类号： TG115.28;TL816
- 收稿日期：2016-02-01，
  
  修回日期：2016-04-06，
  
  纸质出版日期：2016-07
- 稿件说明：
移动端阅览
孙朝明, 汤光平, 王增勇, 等. 数字射线扫描成像系统MTF的测试分析[J]. 核技术, 2016,39(7):070203

Chaoming SUN, Guangping TANG, Zengyong WANG, et al. Analysis of MTF in digital radiography using linear detector array[J]. Nuclear techniques, 2016, 39(7): 070203
孙朝明, 汤光平, 王增勇, 等. 数字射线扫描成像系统MTF的测试分析[J]. 核技术, 2016,39(7):070203 DOI： 10.11889/j.0253-3219.2016.hjs.39.070203.

Chaoming SUN, Guangping TANG, Zengyong WANG, et al. Analysis of MTF in digital radiography using linear detector array[J]. Nuclear techniques, 2016, 39(7): 070203 DOI： 10.11889/j.0253-3219.2016.hjs.39.070203.

摘要

为有效实现数字射线扫描成像检测系统性能的定量分析评价，据此进行检测工艺参数的优化，对数字射线扫描成像检测系统调制传递函数（Modulation transfer function

MTF）进行了测试分析。采用刀口工具、双线型像质计、分辨率测试卡，对系统在不同焦点大小、放大倍数、运动方向的检测情况，分别进行了MTF的测试并进行了比较。结果表明，双线型像质计与分辨率测试卡的测试结果基本一致，但双线型像质计更便于对比度的定量计算；双线型像质计的对比度传递函数近似符合二次曲线，经转换得到的调制传递函数值高于刀口法的测试值，刀口法计算数值偏低的原因在于运动不平稳所带来的不利影响。分析表明，数字射线扫描成像系统性能受到多个因素的共同影响，MTF测试结果可较全面地对影响因素进行定量评价，可用于确定最佳的检测参数或找出等价的参数组合。

Abstract

Background

Nowadays

digital radiography is widely utilized in non-destructive testing. However

some issues concerning this new technique need to be addressed properly

and some key parameters of the imaging system need to be quantified by some measurement methods.

Purpose

To evaluate a digital radiography system using linear detector array quantitatively and efficiently

and optimize the testing parameters accordingly

modulation transfer function (MTF) of the imaging system was calculated and analyzed. Methods: Edge tool

duplex wire image quality indicator (IQI) and resolution test card were used to measure MTF of the system under different testing parameters

which include focus size

magnification and object orientation.

Results

Results show that the contrast transfer function (CTF) measured by duplex IQI and resolution test card is almost identical

while signals from duplex IQI are easier to analyze quantitatively. CTF from duplex IQI is approximately a curve of second order

and the CTF can be used to transform to MTF

but the values are higher than that from edge tool

as movement during image acquisition process is unstable.

Conclusion

After analysis

we find that the system performance is affected by many factors together

but MTF can be used to evaluate these factors perfectly

thus to find out equivalent parameters combination or determine the optimum testing parameters.

关键词

Keywords

references

U Ewert , K Bavendiek , J Robbins , . New compensation principles for enhanced image quality in industrial radiology with digital detector arrays . Materials Evaluation , 2010 . 68 ( 2 ): 163 - 168 .

梁丽红 , 路宏年 . X射线数字成像系统传递函数模型 . 北京航空航天大学学报 , 2005 . 31 ( 9 ): 1018 - 1021 .

Lihong LIANG , Hongnian LU . Transfer function model on X-ray digital radiography system . Journal of Beijing University of Aeronautics and Astronautics , 2005 . 31 ( 9 ): 1018 - 1021 .

邵军明 , 路宏年 , 蔡慧 . X射线成像系统点扩展函数理论模型及其实验验证 . 光学技术 , 2005 . 31 ( 1 ): 104 - 106 .

Junming SHAO , Hongnian LU , Hui CAI . Research of X-ray imaging system point spread function in theory and experiment . Optical Technique , 2005 . 31 ( 1 ): 104 - 106 .

邵军明 , 路宏年 , 候涛 . 射束有效宽度与成像系统MTF关系的研究 . 光学技术 , 2003 . 29 ( 2 ): 242 - 244 .

Junming SHAO , Hongnian LU , Tao HOU . Research of relation between X-ray beam effective width and MTF of imaging system . Optical Technique , 2003 . 29 ( 2 ): 242 - 244 .

Standard guide for radioscopy:ASTM E1000-98(2009)[S]. ASTM International, 2009. DOI: 10.1520/E1000-98R09

Shaw C C, Liu X M, Lemacks M, et al. Optimization of MTF and DQE in magnification radiography-a theoretical analysis[C]. Proceedings of SPIE (International Society for Optical Engineering), 2000, 3977:466-475

T Sakellaris , M Koutalonis , G Spyrou , . A Monte Carlo study of the influence of focal spot size, intensity distribution, breast thickness and magnification on spatial resolution of an a-Se digital mammography system using the generalized MTF . Physica Medica , 2014 . 30 286 - 295 .

K N Chandrasekharan , B P Patil , J K Ghosh . Continuous motion radiography:system evaluation using modulation transfer function . Insight , 1995 . 37 ( 2 ): 101 - 104 .

袁永腾 , 缪文勇 , 丁永坤 , . ICF 流体力学不稳定性实验中调制传递函数的测量 . 强激光与粒子束 , 2009 . 21 ( 2 ): 245 - 248 .

Yongteng YUAN , Wenyong MIAO , Yongkun DING , . Mdulation transfer function measurement in ICF hydrodynamic instability experiments . High Power Laser and Particle Beams , 2009 . 21 ( 2 ): 245 - 248 .

刘海宽 , 张建 , 王昌元 , . 用星形测试卡测试屏-片系统MTF的实验探讨与应用 . 中国医学物理学杂志 , 2006 . 23 ( 4 ): 250 - 252 .

Haikuan LIU , Jian ZHANG , Changyuan WANG , . Testing screen/film system MTF using star testing card . Chinese Journal of Medical Physics , 2006 . 23 ( 4 ): 250 - 252 .

V Kaftandjian , Y M Zhu , G Roziere , . A comparison of the ball, wire, edge, and bar/space pattern techniques for modulation transfer function measurements of linear X-ray detectors . Journal of X-ray Science and Technology , 1996 . 6 205 - 221 .

王雨 , 韩松柏 , 贺林峰 , . 中子照相图像分辨率计算方法 . 核技术 , 2012 . 35 ( 4 ): 275 - 280 .

Yu WANG , Songbai HAN , Linfeng HE , . Calculation methods for neutron radiography spatial resolution . Nuclear Techniques , 2012 . 35 ( 4 ): 275 - 280 .

L E Nickoloff , E Donnelly , L Eve , . Mammographic resolution:influence of focal spot intensity distribution and geometry . Medical Physics , 1990 . 17 ( 3 ): 436 - 447 .

孙朝明 , 汤光平 , 李强 , . X射线源焦点尺寸的测试与对比分析 . 核技术 , 2015 . 38 ( 11 ): 110202 DOI: 10.11889/j.0253-3219.2015.hjs.38.110202 http://doi.org/10.11889/j.0253-3219.2015.hjs.38.110202 .

Chaoming SUN , Guangping TANG , Qiang LI , . Comparative analysis and measurement of focus spot for X-ray source . Nuclear Techniques , 2015 . 38 ( 11 ): 110202 DOI: 10.11889/j.0253-3219.2015.hjs.38.110202 http://doi.org/10.11889/j.0253-3219.2015.hjs.38.110202 .

Standard practice for manufacturing characterization of digital detector arrays:ASTM E2597-14[S]. ASTM International, 2014. DOI:10.1520/E2597_E2597M-14 http://dx.doi.org/DOI:10.1520/E2597_E2597M-14

Pitcher D C. Quantitative metrics to evaluate image quality for computed radiographic images[D]. Florida:University of Florida, 2004

江孝国 , 谭肇 , 李泽仁 , . X光面光源的尺寸对系统线扩展函数的影响 . 强激光与粒子束 , 2004 . 16 ( 3 ): 296 - 300 .

Xiaoguo JIANG , Zhao TAN , Zeren LI , . Influence of X-ray area-source on LSF in radiography system . High Power Laser and Particle Beams , 2004 . 16 ( 3 ): 296 - 300 .

浏览量

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

暂无数据